Tint Tanks Power Pumps Help Page

Important!

  • DO NOT RUN DRY! Be careful to minimize the amount of time your pump is running without liquid flowing through it. This can damage the pump.

  • DO NOT PRESSURIZE your tank when using the Power Pump! 

  • Power Pumps feature a water resistant design and protective case, but it's best to avoid contact with water as much as possible.

  • Remove the battery from the nylon case for charging to avoid overheating.


Getting Started

Charge the battery with the included ac adapter.

SWITCH THE BATTERY TO ON FOR CHARGING.

The LED on the power adapter will light up red while charging, and turn green when charging is complete. Your Power Pump is now ready to use!

Make sure there is no air pressure in your tank by releasing the PRV valve in the lid for a few seconds. Pull up and turn on the PRV ring to lock it to the open position, as shown here:


This will allow air into your tank, making it easier for the pump to draw water out.

Next, secure the Power Pump to your tank using the hanging strap. It's best to position it near the OUT post, as shown here: 

Attach the Power Pump's black quick connector to your tank's OUT post by lifting the base ring and pushing / twisting the connector down until it clicks into place.

Attach your hose connector to the Power Pump's OUT post.

Set the battery power switch to ON

Hold the trigger of your hose's spray gun for a few seconds, until the pump has been primed and you are getting a consistent flow of liquid from the pump. 

Once primed, the pump will run intermittently, only as needed to supply pressure. This maximizes efficiency by minimizing power consumption.

When finished, disconnect the Power Pump from your tank, pump out any remaining liquid in your hose, then disconnect your hose.

Is your Power Pump running, but not moving liquid?

If your PRV is propped open as shown above, but your pump is not pulling liquid from your tank, you may need to prime the pump to make sure it's not running dry. A dry pump can't create a vacuum seal to draw liquid from the tank, and will wear out quickly if run continuously.

With your Power Pump connected to a filled tank, spray several short bursts in rapid succession, until you see liquid in the intake hose that connects to your tank. Repeat until your pump is working normally. 

TIP: Spray directly back into your tank to conserve product!